Roller Wheels

“Roller guidance drive system” is
realized to keep in maintenance
rollers just extracted by kiln.

In effect, due to the high
temperature, if rollers aren’t
maintained in constant rotation and
to the same kiln speed upon their
temperature’s decreasing, can be
subject of permanent damaging
which compromises the use.

The drive system is structured in
manner that roller’s can’t deforms
upon defined tolerances.

The “Roller guidance drive system” is fully
realized by railed profiles in aluminium and
it’s furnished of spinning wheels, so it
guarantees major lightly and manoeuvrability
for the “ keep in service”.

On the structure is mounting double conical
gears box with acts by a manual motovariator
which permits regulation of the number of
rotation spins of supporter’s rollers.

To the opposite part of dragging are
placket idle rollers, which are by
sustain of the second lateral side of
roller; these are fixed to a power loom
regulation support which permits the
laying with variable length from 2500
to 3800 mm. and variable diameters
from 30 up to 55 mm.

The conical pairs motion is transmitted to
knurled pivots that permit the spinning to the
mounted rollers.

The lower side is furnished by a plane sheet,
useful for use like cooled rollers warehousing.

The system permits the drive up to 23 rollers.

Is possible to satisfy every request relative to
Number rollers

Rollers diameters.

Rollers length.

Number RPM.